Is your engine consuming more oil than it is supposed to do? There can be several reasons.
Oil Leakage
The crankshaft is usually the culprit on the diesel engine’s exterior. If it is checked and found innocent, proceed inwards. There may be leakage in the seals at the end of the crankshaft. Then move towards the oil pan gasket and lubrication connections. After that take a close look at the crankcase breather, which is very often responsible for leaks.
Oil Consumption into Combustion Area
- Blue smoke is a sign of burning oil in the combustion chamber. Sometimes wear and tear causes the oil to leak into the combustion chamber.
- Oil is most likely to leak between worn valve guides and valve stems. It is advisable to check and replace worn out parts like pistons, piston rings and liners.
- Clogged oil return galleries in the bearings also cause leaks and sometimes faulty installation of compression and intermediate rings are also responsible. Leakages tend to occur past the seal rings in the impeller end of the turbo shaft.
- Incorrect viscosity can also result in increased oil consumption. It is not advisable to use synthetic oil for a brand-new engine as it is too thin and doesn’t give sufficient time for the gaskets, liners, rings, and bearings to set properly. It is recommended that a standard oil be used for the first 7500 kms, after that it is safe to switch to synthetic oil.
Why does the temperature of the oil increase?
When there is a blockage in the oil galleries in the oil cooler, the temperature will rise – this is by far the most common cause. When the oil cooler malfunctions, oil will not come down to the required temperature.
Sometimes, a pressure-sensitive allows unfiltered, uncooled oil in the system. This happens when a system in the engine requires excessive lubrication.
If your engine is consuming more oil, usually there is no cause for alarm, it need not be a sign of immediate engine trouble. Diesel engines are manufactured to last a long time as long as they are maintained competently – oil is changed regularly, worn parts are replaced. If you do notice a rise in temperature or a leak, it is advisable to shut down the engine and call for expert help.
To know more about our products visit us at www.krasspower.com or talk to our expert at +91 9664863249
Frequently Asked Questions
Diesel generators are one of the most common forms of standby power in the world.
A diesel generator produces electricity through a combination of a diesel engine with an electric generator. The power of the diesel generator is transformed by the alternator into a usable electrical current. This reliable source of power is often used by many businesses and homes for protection against power failure.
Diesel generators are commonly used by a variety of different organisations including data centers, banks, hospitals and factories. It’s vital to take action on your power back-up – no business is too big or small to have a diesel generator solution in place.
Within a typical diesel generator, you will find a diesel internal combustion engine that is used to drive an electric generator, commonly referred to as an alternator, to produce electrical energy. The alternator creates power by turning mechanical energy into electrical energy, by rotating magnets surrounding a coil. As these magnets spin, they create an alternating current around the coil which is then transformed into usable electrical power by an internal rectifier.
Diesel generators are renowned for their robustness and durability, and with proper maintenance by trained professionals using genuine parts, they can run for several years. The lifespan of a diesel generator can typically range from 10 to 30 years, depending on the model, how often the machine is used, and what preventative maintenance has been used during the machine’s lifetime.
Air filter: 1000 hours, can be more different environments to shorten the replacement cycle.
Diesel filter: the first work is 50 hours to replace after the general is 400 hours to replace. If the user uses diesel fuel which quality is not good, shorten the replacement cycle.
Oil filter: 50 hours to replace the first work, after the general is 200 hours to replace.